
Maker builds Mad Max-inspired wall of 100 Noctua PC fans
A wall of 100 Noctua PC fans was built by maker Sasa Karanovic because "why not." There's a little more to it, though, as the Toronto-based electronics and 3D printing expert wanted to test the capabilities of his new open-source open-hardware OpenFAN XL fan controller. A video shows the setup and control of a 10x10 Noctua fan grid controlled via the 10 headers on the controller. A 50x2 setup was also shown working off the controller. Karanovic indicates that 100 fans was "no sweat" for the new controller, but it would max out at around 200 spinners in its current iteration.
The maker explains in the video that they had this demo idea a while back but recently acquired 100 fans through a combination of "a ton of luck and a good friend." As the new OpenFAN XL controller has 10 headers, the natural first step in controlling them all was to make a grid of 10 x 10 units. …
You're reading a preview. The full article is published by Tom's Hardware on their website.
Read the full story on Tom's Hardware

